Configuring the Switch
3-176
3
Web – Click MVR, Configuration. Enable MVR globally on the switch, select the
MVR VLAN, add the multicast groups that will stream traffic to attached hosts, and
then click Apply.
Figure 3-106 MVR Global Configuration
CLI – This example first enables IGMP snooping, enables MVR globally, and then
configures a range of MVR group addresses.
Displaying MVR Interface Status
You can display information about the interfaces attached to the MVR VLAN.
Field Attributes
• Type – Shows the MVR port type.
• Oper Status – Shows the link status.
• MVR Status – Shows the MVR status. MVR status for source ports is “ACTIVE” if
MVR is globally enabled on the switch. MVR status for receiver ports is “ACTIVE”
only if there are subscribers receiving multicast traffic from one of the MVR groups,
or a multicast group has been statically assigned to an interface.
• Immediate Leave – Shows if immediate leave is enabled or disabled.
• Trunk Member
12
– Shows if port is a trunk member.
Console(config)#ip igmp snooping 4-202
Console(config)#mvr 4-218
Console(config)#mvr group 228.1.23.1 10 4-218
Console(config)#
12. Port Information only.
To Next Page
Loading...
Need help?
General
