Command Line Interface
4-84
4
dot1x re-authenticate
This command forces re-authentication on all ports or a specific interface.
Syntax
dot1x re-authenticate [interface]
interface
• ethernet unit/port
- unit - Stack unit. (Always unit 1)
- port - Port number. (Range: 1-26/50)
Command Mode
Privileged Exec
Example
dot1x re-authentication
This command enables periodic re-authentication globally for all ports. Use the no
form to disable re-authentication.
Syntax
[no] dot1x re-authentication
Command Mode
Interface Configuration
Example
dot1x timeout quiet-period
This command sets the time that a switch port waits after the Max Request Count
has been exceeded before attempting to acquire a new client. Use the no form to
reset the default.
Syntax
dot1x timeout quiet-period seconds
no dot1x timeout quiet-period
seconds - The number of seconds. (Range: 1-65535)
Default
60 seconds
Console#dot1x re-authenticate
Console#
Console(config)#interface eth 1/2
Console(config-if)#dot1x re-authentication
Console(config-if)#
To Next Page
Loading...
Need help?
General
