VLAN Commands
4-173
4
switchport allowed vlan
This command configures VLAN groups on the selected interface. Use the no form
to restore the default.
Note: Each port can only have one untagged VLAN. If a second VLAN is defined for
a port as untagged, the other VLAN that had untagged status will
automatically be changed to tagged. Setting a VLAN untagged will also
change the native VLAN of the port to this VLAN.
Syntax
switchport allowed vlan {add vlan-list [tagged | untagged] |
remove vlan-list}
no switchport allowed vlan
• add vlan-list - List of VLAN identifiers to add.
• remove vlan-list - List of VLAN identifiers to remove.
• vlan-list - Separate nonconsecutive VLAN identifiers with a comma and no
spaces; use a hyphen to designate a range of IDs. Do not enter leading
zeros. (Range: 1-4094).
Default Setting
All ports are assigned to VLAN 1 by default.
The default frame type is untagged.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• A port, or a trunk with switchport mode set to hybrid, must be assigned to a
VLAN as untagged.
• If a trunk has switchport mode set to trunk (i.e., 1Q Trunk), then you can only
assign an interface to VLAN groups as a tagged member.
• Frames are always tagged within the switch. The tagged/untagged parameter
used when adding a VLAN to an interface tells the switch whether to keep or
remove the tag from a frame on egress.
• The interface can be added to a VLAN as an untagged member regardless of
connected devices to this interface. The default setting is untagged VLAN 1.
Note that each port can only have one untagged VLAN. If a second VLAN is
defined for a port as untagged, the other VLAN that had untagged status will
automatically be changed to tagged. Setting a VLAN untagged will also
change the native VLAN of the port to this VLAN.
• If a VLAN on the forbidden list for an interface is manually added to that
interface, the VLAN is automatically removed from the forbidden list for that
interface.
To Next Page
Loading...
Need help?
General
