Step
2:
Charging
the
battery
pack
POWER switch
I
•..
V!'..;.;'---------j
1
Power cord
To the wall outlet
22
You can charge the "lnfoLiTHIUM"
battery pack (H series) (p. 106) after
attaching it to your camcorder.
" Notes
• You can use only "InfoLITHIUM" battery pack
H series.
1 Turn the POWER switch
in
the
direction of the arrow to OFF
(CHG) (The default setting).
2 Attach the battery pack by sliding
it
in
the direction of the arrow
until it clicks.
Lift up the viewfinder and attach
the battery pack by sliding it
in
the direction of the arrow until it
clicks.
3 Connect the AC Adaptor to the
DC
IN
jack of your camcorder.
Open the jack cover, and connect the
DC plug
of
the AC Adaptor.
Match the
.A
mark on the DC plug with
the
.A
mark on your camcorder.
---_._-----------
4 Connect the power cord to the AC
Adaptor and the wall outlet.
The CHG (charge) lamp lights up and
charging starts. The CHG (charge) lamp
turns
off
when the battery is fully
charged.
5 Disconnect the AC Adaptor from
the DC
IN
jack on your
camcorder.
" Notes
• Disconnect the AC Adaptor from the DC IN
jack holding both the camcorder and the DC
plug.
To Next Page
Loading...
Need help?
Imaging
Audio
Display
Power
