26
4 Set [V] (year) with
AlT.
5 Select [M] with
"/~,
then set the
month with
AI".
6 Set
[0]
(day), hour and minute
in
the same way, then touch [NEXT].
7 Make sure that the clock
is
correctly set, then touch
!oKI.
The clock starts.
You can set any year up to the year
2037.
For midnight, set it to 12:00 AM.
For midday, set it to 12:00 PM.
To
turn
off
the
power
Turn the
POWER
switch to OFF (CHG).
To
reset
the
date
and
time
Selectt\
(HOME)
--+
;i,(SETTINGS)
--+
[CLOCKI[fJ3LANG]
--+
[CLOCK SET],
and set the date and time.
"
Notes
•
If
you do not use your camcorder for about 3
months,
the built-in rechargeable battery gets
discharged and the date and time settings may
be cleared from the memory. In that case,
charge the rechargeable battery and then set the
date and time again (p. 109).
• It takes a few seconds for your camcorder to be
ready to shoot after the power
is
turned on. You
cannot operate your camcorder during this time.
• The lens cover opens automatically when the
power is turned on.
It
closes when the playback
screen
is
selected, or the power is turned off.
• In the setting at the time
of
purchase, the power
turns off automatically if you leave your
camcorder without any operation attempted for
approximately 5 minutes, to save battery power
([A.SHUT OFF],
p.
75).
'Q*
Tips
• The date and time does not appear during
recording, but they are automatically recorded
on the disc, and can be displayed during
playback (see page
71
for [DATA CODE]).
• Refer to page 102 for information concerning
"World time difference."
•
If
the buttons on the touch panel do not work
correctly, adjust the LCD screen
([CALIBRATION], p. 108).
Changing
the
language
setting
You can change the on-screen displays to
show messages in a specified language.
Touch
ft
(HOME)
--+
til
(SETTINGS)--+[CLOCKI
[fJ3LANG]--+[[fJ3LANGUAGE SET], then
select the desired language.
To Next Page
Loading...
Need help?
Imaging
Audio
Display
Power
