Charging time
Approximate time (min.) required when you fullycharge a fully dischargedbattery pack.
NP- FVS0 (supplied) 1.5.5 315
NP-FV70 195 600
NP-FV100 390 1050
• The charging times shown in the table above are measured when charging the camcorder at a
temperature of 25 °C (77 °F). It is recommended that you charge the battery in a temperature range of 10
°C to 30 °C (50 °F to 86 °F).
x The charging times are measured without using the USB Connection support cable.
OTips
• See page 61 on recording and playing time.
• When your camcorder is on, you can check the approximate amount of remaining battery power with the
remaining battery indicator at the upper right on the LCD screen.
To remove the battery pack
(;lose the LCD screen. Slide the BATT (battery) release lever ((_)) and remove the battery
pack (@).
cq
5
To use a wall outlet (wall socket) as a power source
Make the same connections as "Step 1: Charging the battery pack" (p. 13). Even if the battery
pack is attached, the battery pack is not discharged.
Notes on the battery pack
• When you remove the battery pack or disconnect the A(" Adaptor, turn the camcorder off and make sure
that the _ (Movie)/l_ (Photo) lamps (p. 24), the access lamp (p. 22) are turned off-
• The CHG (charge) lamp flashes during charging under the fbllowing conditions:
- The battery pack is not attached correctl3c
- The battery pack is damaged.
- The temperature of the battery pack is lox_c
Remove the battery pack fl'om your camcorder and put it in a warm place.
- The temperature of the battery pack is high.
Remove the battery pack fl'om your camcorder and put it in a cool place.
_5
To Next Page
Loading...
Need help?
General