Sony ICP-X7000 User Manual

356
3 While pressing the [MCRO] button, press the button
for the target register for operation.
This switches the Flexi Pad control block to macro
editing mode, and the [MCRO] button changes color
to red.
The selected bank and register number are displayed
on the top right button in the memory recall section,
and the number of the current event and total number
of events are displayed on the center button in the
bottom row.
4 If required, set auto insert mode (see page 355).
5 Create the events (carry out the control panel
operations to be registered as events in the macro).
You can also include pause events (see page 357).
For details about the events that can be registered, see
“Events” (page 346).
When auto insert mode is enabled, the event is
registered automatically.
When auto insert mode is disabled, press the [INS]
button to register the event.
• During macro editing, if you press any of the mode
selection buttons in the Flexi Pad control block other
than the [MCRO] button, the executed operation is
also registered as an event. In this case, the [MCRO]
button remains lit red.
• While editing a macro in the Flexi Pad control block,
pressing a button which has macro attachment does
not execute the macro.
6 Repeat steps 4 and 5 to register the required events in
the macro.
This registers the events in the macro, in the order the
operations were carried out on the control panel.
7 Press the [STORE XXX] button (where XXX is the
number of the currently selected register).
This saves the created macro in the register.
To exit macro creation without saving, press the
[EXIT] button.
Specifying an edit point
1 In the Flexi Pad control block, press the [MCRO]
button.
This switches the memory recall section to macro
operation mode.
The last recalled bank is displayed.
2 Use the bank selection buttons to select the target bank
for operation.
Select from bank 0 to 25 (register number 1 to 250).
For details about bank selection, see “Bank and
register selection in the Flexi Pad control block”
(page 332).
3 While pressing the [MCRO] button, press the button
for the target register for operation.
This switches the Flexi Pad control block to macro
editing mode, and the [MCRO] button changes color
to red.
The selected bank and register number are displayed
on the top right button in the memory recall section,
and the number of the current event and total number
of events are displayed on the center button in the
bottom row.
4 Specify an edit point.
• To move the edit point to the event immediately
following the current event, press the [>> NEXT]
button.
• To move the edit point to the event immediately
preceding the current event, press the [<< PREV]
button.
Inserting an event
1 Specify an edit point (see page 356).
2 If required, set auto insert mode (see page 355).
3 Create an event.
When auto insert mode is enabled, the event is
registered after the current event automatically.
When auto insert mode is disabled, press the [INS]
button to register the event after the current event.
4 Repeat steps 2 and 3 to insert the required events in the
macro.
Modifying an event
1 Specify an edit point (see page 356).
2 Disable auto insert mode if it is enabled.
3 Create an event.
4 Press the [MOD] button.
Notes

Sony ICP-X7000 Specifications

General

Brand	Sony
Model	ICP-X7000
Category	Switch
Language	English