MHC-V82D/MHC-V72D.GB.5-000-538-13(1)
Additional Information
71
GB
Precautions
When carrying the unit
To avoid damaging the disc
mechanism, perform the following
procedure before carrying the unit.
Use the controls on the unit to
perform this operation.
1 Press to turn on the system.
2 Touch FUNCTION repeatedly to
select “DVD/CD”.
3 Remove the disc.
Touch to open and close the disc
tray.
Wait until “NO DISC” appears on the
display.
4 Press to turn off the system.
5 Unplug the AC power cord (mains
lead).
Notes on discs
••
Before playing, wipe the disc with a
cleaning cloth from the center outward
to the edge.
••
Do not clean discs with solvents, such
as benzine, thinner, or commercially
available cleaners or anti-static spray
intended for vinyl LPs.
••
Do not expose discs to direct sunlight
or heat sources such as hot air ducts,
nor leave them in a car parked in direct
sunlight.
On safety
••
Completely disconnect the AC power
cord (mains lead) from the wall outlet
(mains) if it is not going to be used
for an extended period of time. When
unplugging the system, always grip the
plug. Never pull the cord itself.
••
Should any solid object or liquid get
into the system, unplug the system, and
have it checked by qualified personnel
before operating it again.
••
AC power cord (mains lead) must be
changed only at the qualified service
shop.
On handling the system
••
Do not splash water on the unit
on purpose. Dust and drip proof
performance is improved by the flat
top structure of the unit, but this is not
guaranteed for all the situations. If you
accidentally splash liquid on the unit,
wipe off immediately.
••
To maintain the dust and drip proof
performance, make sure all the covers
of the jacks/port/terminal are securely
closed.
On placement
••
Do not place the system in an inclined
position or in locations that are
extremely hot, cold, dusty, dirty, or
humid or lacking adequate ventilation,
or subject to vibration, direct sunlight or
a bright light.
••
Be careful when placing the system
on surfaces that have been specially
treated (for example, wax, oil, polish) as
staining or discoloration of the surface
may result.
••
If the system is brought directly from
a cold to a warm location or is placed
in a very damp room, moisture may
condense on the lens inside the unit,
and cause the system to malfunction.
In this situation, remove the disc, and
leave the system turned on for about an
hour until the moisture evaporates.
On heat buildup
••
Heat buildup on the unit during
operation is normal and is not a cause
for alarm.
••
Do not touch the cabinet if it has been
used continuously at a high volume
because the cabinet may have become
hot.
••
Do not obstruct the ventilation holes.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
