Setting the Date/Time of the Internal Clock
41
Chapter 2 Preparations
3 Turn the MENU knob to display the
desired area of use.
a) The composite signal output from this unit is an
NTSC signal with no black setup. The system
frequency is 59.94i.
b) The composite signal output from this unit is an
NTSC signal with a black setup (7.5 IRE). The
system frequency is 59.94i.
c) The composite signal output from this unit is a
PAL signal. The system frequency is 50i.
4 Change the SYSTEM LINE (video
resolution) setting as required.
5 Set the POWER switch to OFF, then
once again to ON.
The unit is now ready for use.
You can set or change the date and time of the
internal clock. The date and time set are reflected
in the timecode.
(How to select an item in the menu screen: Turn
the MENU knob to move b to the desired item.)
1 Display the TIME/DATE page of the
DIAGNOSIS menu, and press the
MENU knob.
For details on menu operations, see “Basic
menu operations” on page 163.
2 Press the MENU knob.
The TIME ADJUST setting window appears.
• HOUR: Sets the hour value.
• MIN: Sets the minutes value.
• SEC: Sets the seconds value.
• YEAR: Sets the year.
• MONTH: Sets the month.
• DAY: Sets the day.
3 Turn the MENU knob to move b to the
item you want to set, and press the
MENU knob.
b on the left of the selected item changes to
z and z on the left of the setting changes to
?.
Setting Area of use
NTSC (J) AREA
NTSC area (Japan)
a)
NTSC AREA NTSC area (for areas other
than Japan)
b)
PAL AREA
PAL area
c)
Setting Resolution (horizontal × vertical)
1080 1080 lines (1920 × 1080)
720 720 lines (1280 × 720)
Setting the Date/Time of
the Internal Clock
ADJUST : EXEC
HOUR : 12
MIN : 55
SEC : 58
YEAR : 08
MONTH : 03
DAY : 31
D02 TIME/DATE TOP
HOUR : 12
MIN : 55
SEC : 58
YEAR : 08
MONTH : 03
DAY : 31
OK
TIME ADJUST ESC
To Next Page
Loading...
Need help?
General
