Sony SA-WX9000F User Manual

HT-X9000F/XF9000
25
2-19. SK1 AMP BOARD
right side
left side
5 heatsink
Note 2:
When installing the heatsink, align
the two bosses and two holes.
boss
boss
hole
hole
rib
rib
hole
hole
front side
top side
main chassis block
1 flexible flat cable (28P)
(CN6005)
2 SK1 AMP board cable
connector (CN6001)
terminal side
3 POWER board cable
connector (CN6002)
6 screw
(BVTP3 u 8)
4 two screws
(BVTP3 u 10)
6 screw
(BVTP3 u 8)
6 screw
(BVTP3 u 8)
7
8 SK1 AMP board
Note 3:
When installing the SK1 AMP board,
align the two ribs and two holes.
9 sheet radiation
(14.0 u 10.0 mm)
9 sheet radiation
(14.0 u 10.0 mm)
9 sheet radiation
(14.0 u 10.0 mm)
9 sheet radiation
(14.0 u 10.0 mm)
Press.
Press.
Press.
:LUHVHWWLQJUHIHUHQFH
CN6002
SK1 AMP board
–7RSYLHZ–
rear side
POWER board
CN6001
MAIN board
Note 1: When the SK1 AMP board is replaced, spread the compound
to the touching portion between the IC6006 and the heat sink.

Sony SA-WX9000F Specifications

General

Brand	Sony
Model	SA-WX9000F
Category	Speaker System
Language	English