5: Preparingthereceiver
andthe remote
If your receiver has a voltage selector on the
rear panel, check that the voltage selector is set
to the local power supply voltage. If not, use a
screwdriver to set the selector to the correct
position before connecting the AC power cord
to a wall outlet.
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defuults.
Be sure to use the buttons on the receiver for
this operation.
1,2
Connect the AC power cord (mains lead) to a
wall outlet.
AC power cord (mains lead)
To the wall outlet
1
2
3
3
Press I/(_ to turn off the
receiver.
Hold down I/_ for 5 seconds.
"PUSH" and "ENTER" appears on the
display alternately.
Press MEMORY/ENTER.
After "CLEARING" appears on the
display for a while, "CLEARED"
appears.
The following items are reset to their
fuctory settings.
• All settings in the LEVEL, TONE,
SUR, TUNER, AUDIO and SYSTEM
nlenus.
• The sound fiekt memorized for each
input and preset station.
• All sound field parameters.
• All preset stations.
• All index names for inputs and preset
stations.
• MASTER VOLUME is set to "VOL
MIN".
• Inpnt is set to "DVD".
26G8
To Next Page
Need help?
General
