Changingbutton
assignments
You can change the factory settings of the
input buttons to suit the components in your
system. For example, if you connect a DVD
recorder to the VIDEO I jacks on the receiver,
you can set the VIDEO 1 button on this remote
to control the DVD recorder.
1 Hold down the input button of
which you want to change the
assignment.
Example: HoM down VIDEO 1.
2 Referring to the table below,
press the corresponding
button for the category you
want.
Example: Press 4.
Now you can use the VIDEO 1 button to
control the DVD recorder.
Categories and the
corresponding buttons
Categories Press
VCR (command mode VTR 3) a) 1
VCR (command mode VTR 2) a) 2
DVD player/DVD recorder 3
(command mode DVD 1)b)
DVD recorder 4
(command mode DVD3) b)
CD player 5
Euro Digital Satellite Receiver 6
DVR (Digital CATV terminal) 7
DSS (Digital Satellite Receiver) 8
Blu-ray disc player 9
(command mode BDI )c)
Blu-ray disc recorder 0110
(command mode BD3) c)
TV -1--
Not assigned ENTER/
MEMORY
a/Sony VCRs are operaled wifll a VTR 2 or VTR 3 r'-
setting which corresponds to 8 mm and VHS
respeclively. I.Q
b)Sony DVD recorders are operaled wilh a DVD l or
DVD3 selling. For details, refer to the operaling XI
instructions supplied with the DVD recorders. •
3
C/For details on the BDI or BD3 setting, refer to the O
operaling instructions supplied wilh the blu-ray •
disc player or blu-ray disc recoMer.
To clear all remote button
assignments
Press I/(,D, AUTO CAL and MASTER VOL -
at the same time.
The remote is reset to its factory settings.
61G8
To Next Page
Loading...
