5
6
7
Press 4,1,!,repeatedly to select
"T. TONE Y".
The test tone is output from each speaker
in sequence as follows:
Front left _ Center _ Front right
Surround right _ Surround left
Sub woofer
Adjust the speaker levels and
balance using the LEVEL menu
so that the level of the test tone
sounds the same from each
speaker.
For details, see "Adjusting the level
(LEVEL menu)" (page 39).
Tips
• To adjust the level ol all speakers at the same
time, press MASTER VOL +_. You carl also
use MASTER VOLUME on the receive_:
• The ac{iusted value is shown on the display
during adjustment.
Repeat steps 1 to 5 to select
"T. TONE N".
Youcan also press any input buttons.
The test tone turns oft'.
When a test tone is not output
from the speakers
• The speaker cords may not be connected
securely.
• The speaker cords may have the short-circuit
problem.
Note
Tile test tone does not work wheu ANALOG
DIRECT is selected.
Selectinga component
MUTING
3
Press the input button to select
a component.
You can also use INPUT SELECTOR on
the receiver.
The selected input appears on the display.
32 G8
To Next Page
Loading...
Need help?
General
