Sony STR-DG510 User Manual

Kb
Input
MUTING
MASTER
Press AUTO CAL.
Measnrement starts ill 5 seconds and tire
display changes as follows:
A.CAL 151 -+ A.CAL 141 -'+ A.CAL 13]
--+ A.CAL [21 -'+ A.CAL 11]
While the time is counting down, stand
away from the measnrement area to avoid
measurement erroE
2
Measurement starts.
The nleusurement process will take a few
minutes to complete, if)
o
The table below shows the display when
nleasnrenlent starts. "_
_t
Measurement for Display
Environment noise NOISE.CHK ;:I,,
level
Speaker cenneclion MEASURE and SP
DET. appears
alternately _-
Speaker level MEASURE and (IAIN
appears alternately _
Speaker distance MEASURE and
DISTANCE appears
allernalely !-
3
4
_ The corresponding speaker indicator lights
up in the display during measurement.
Measurement ends.
"COMPLETE" appears on the display
and the settings are registered.
Disconnect the optimizer
microphone from the AUTO
CAL MIC jack.
Note
Auto Calihration cantlot detect the sub wooli:r.
Therelore. all sub wooti:r settings will be
maintained.
Tip
During the measurement process. Auto Calihration
is canceled when you do the lbllowing.
Press I/(_), input buttons or MUTING.
Change the volume level.
Press AUTO CAL again.
29G8

Sony STR-DG510 Specifications

General

Power Output	100 Watts per channel
Number of Channels	5.1
HDMI Inputs	2
HDMI Outputs	1
Dolby Digital	Yes
DTS	Yes
FM/AM Tuner	Yes
Component Video Inputs	2
Component Video Output	1
Digital Audio Inputs (Optical)	2
Digital Audio Inputs (Coaxial)	1
Analog Audio Inputs	4
Headphone Jack	Yes
Frequency Response	10 Hz - 100 kHz
Dimensions	430 x 157.5 x 315 mm (16 15/16 x 6 1/4 x 12 1/2 inches)
Inputs	HDMI, Component Video, Digital Audio (Optical/Coaxial), Analog Audio
Outputs	HDMI, Component
Supported Audio Formats	Dolby Digital, DTS
Output Power	100W per channel (8 ohms, 20Hz-20kHz, 0.09% THD)