There is severe hum or noise.
• Check that the speakers and components
are connected securely.
• Check that the connecting cords are away
from a transformer or motor, and at least 3
in (10 feet) away from a TV set or
fluorescent light.
• Move your audio components away from
the TV.
• The plugs and jacks are dirty. Wipe them
with a cloth slightly moistened with
alcohol.
There is no sound, or only a very low-
level sound is heard from the center/
surround speakers.
• Select a CINEMA STUDIO EX mode
(page 49).
• Ac[inst the speaker level (page 31).
• Make sure the center/surronud speakers
are set to either "SMALL" or "LARGE"
(page 38).
There is no sound from the sub woofer.
• Check that the sub woofer is connected
correctly and securely.
• Make sure you have turned on your sub
woofer.
• Make sure the sub woofer is set to "YES"
(page 38).
• There is no sound from the sub woofer
depending on the sound fieM.
There is no sound from the speakers of
the receiver when you connect the
receiver and the playback component
via a HDMI connection.
• Make sure that you have connected tile
digital audio jacks on the playback
component to the receiver. Then, turn off
or mute the TV's volume.
The surround effect cannot be
obtained.
• Make sure the sound fieM function is on
(press MOVIE, or MUSIC).
• Sound fieMs do not function for signals
with a sampling frequency of more than
48 kHz.
Dolby Digital or DTS multi channel
sound is not reproduced.
• Check that the DVD, etc. you are playing
is recorded in Dolby Digital or DTS
format.
• When connecting the DVD player, etc., to
the digital input jacks of this receiver,
check the audio setting (the settings for the
audio outpnt) of the connected component.
Video
There is no picture or an unclear
picture appears on the TV screen.
• Select the appropriate input using tile input
buttons.
• Set your TV to the appropriate input mode.
• Move your audio components away from
the TV.
The source image input to the HDMI
jack on the receiver is not output from
the TV. 5"
• Check the HDMI connection.
• Depending on the playback component, 5"
you may need to set up the component. _'
Refer to the operating instructions
a.
supplied with each component. 5"
Recording cannot be carried out.
• Check that tile components are connected
correctly.
• Select the source component using the
input buttons.
continued_
65G8
To Next Page
Loading...
Need help?
General
