On
placement
• Place the receiver
in
a location with adequate
ventilation to prevent heat buildup and
prolong the life
of
the receiver.
• Do not place the receiver near heat sources,
or in a place subject to direct sunlight,
excessive dust,
or
mechanical shock.
• Do not place anything on top
of
the cabinet
that might block the ventilation holes and
cause malfunctions.
• Do not place the receiver near equipment
such as a television, VCR,
or
tape deck. If
the receiver is being used
in
combination
with a television, VCR,
or
tape deck, and is
placed too close to that equipment, noise
may result, and picture quality may suffer.
This
is
especially likely when using an
indoor antenna (aerial). Therefore, we
recommend using an outdoor antenna
(aerial).
• Use caution when placing the receiver on
surfaces that have been specially treated
(with wax, oil, polish, etc.) as staining
or
discoloration
of
the surface may result.
On
operation
Before connecting other components, be sure
to turn
off
and unplug the receiver.
On
cleaning
Clean the cabinet, panel, and controls with a
soft cloth slightly moistened with a mild
detergent solution. Do not use any type
of
abrasive pad, scouring powder,
or
solvent,
such as alcohol
or
benzine.
If
you have any questions
or
problems
concerning your receiver, please consult your
nearest Sony dealer.
30
GB
Troubleshooting
If
you experience any
of
the following
difficulties while using the receiver, use this
troubleshooting guide to help you remedy the
problem.
There
is
no
sound, no matter which
component
is
selected, or only a very
low-level sound
is
heard.
• Check that the speakers and components
are connected correctly and securely.
• Check that both the receiver and all
components are turned on.
• Check that MASTER
VOLUME
is
not set
to
"VOL
MIN".
• Check that the
SPEAKERS
(OFFIAIBI
A+B) is not set to
"OFF".
• Check that headphones are not connected.
• Press MUTING to cancel the muting
function.
• Check that you have selected the correct
component with the input buttons.
• The protective device on the receiver has
been activated. Turn
off
the receiver,
eliminate the short-circuit problem, and
tum on the power again.
There
is
no sound from a specific
component.
• Check that the component is connected
correctly to the audio input
jacks
for that
component.
• Check that the cord(s) used for the
connection is (are) fully inserted into the
jacks on both the receiver and the
component.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
