54
GB
[Error 35: FL], [Error 35: FR],
[Error 35: SL], [Error 35: SR],
[Error 35: FC], [Error 35: SW],
[Error 35: SBL], [Error 35: SBR],
[Error 35: SB], [Error 35: HTL],
[Error 35: HTR]
The speaker pattern configuration does not
match calibration result, or the noise level
is high. Please check the speaker pattern
and connection, or re-calibrate in a quiet
environment.
[Warning 40:]
The measurement has been completed,
but the noise level is high. For best possible
results, calibrate in as quiet a place as
possible.
[Warning 41:], [Warning 42:]
The input signal from the calibration
microphone is too large. The microphone
may be too close to the speakers. Please
place the calibration microphone at your
desired listening position, and perform
Auto Calibration again.
[Warning 43:]
The distance and position of the subwoofer
cannot be detected. Please check the
subwoofer and re-calibrate in a quiet
environment.
Precautions
On safety
Should any solid object or liquid fall into
the cabinet, unplug the receiver and have it
checked by qualified personnel before
operating it any further.
On power sources
• Before operating the receiver, check that
the operating voltage is identical with
your local power supply.
The operating voltage is indicated on the
nameplate on the rear of the receiver.
• If you are not going to use the receiver for
a long time, be sure to disconnect the
receiver from the wall outlet. To
disconnect the AC power cord (mains
lead), grasp the plug itself; never pull the
cord.
• The AC power cord (mains lead) must be
changed only at a qualified service shop.
On heat buildup
Although the receiver heats up during
operation, this is not a malfunction. If you
continuously use this receiver at a large
volume, the cabinet temperature of the
top, side and bottom rises considerably. To
avoid burning yourself, do not touch the
cabinet.
On placement
• Place the receiver in a location with
adequate ventilation to prevent heat
buildup and prolong the life of the
receiver.
• Do not place the receiver near heat
sources, or in a place subject to direct
sunlight, excessive dust, or mechanical
shock.
• Do not place anything on top of the
cabinet that might block the ventilation
holes and cause malfunctions.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
