Insert two R03 (size AAA) batteries (supplied) into the remote control. Make sure that the +
and - ends are in the correct position when installing batteries.
Note
Do not leave the remote control in an extremely hot or humid place.
Do not use a new battery with an old one.
Do not mix manganese batteries with other kinds of batteries.
Do not expose the remote control sensor to direct sunlight or lights. Doing so may cause
a malfunction.
If you do not intend to use the remote control for an extended period of time, remove the
batteries to avoid possible damage from battery leakage and corrosion.
When the receiver no longer responds to the remote control, replace both of the batteries
with new ones.
[23] Preparation
Turning on the receiver/preparing the remote control
Turning on the receiver
When you have made all connections with the other devices, connect the AC power cord
(mains lead), then turn on the receiver.
1. Connect the supplied AC power cord (mains lead) to the AC IN terminal on the receiver
firmly, then connect the AC power cord (mains lead) to a wall outlet.
AC IN terminal
AC power cord (mains lead) (supplied)
To Next Page
Loading...
Need help?
General
