[2ch Analog Direct] is being used.
[Auto Calibration] has not been performed.
The receiver may play signals at a lower sampling frequency than the actual sampling
frequency of the input signals, depending on the audio format.
[64] Adjusting Settings
Speaker Setup
Selecting the Auto Calibration type (Calibration Type)
You can select a calibration type after you have performed the Auto Calibration and saved
the settings.
1. Select [Setup] - [Speaker Setup] from the home menu.
2. Select [Calibration Type].
3. Select the setting you want.
Full Flat: Makes the measurement of frequency from each speaker flat.
Engineer: Sets to “the Sony listening room standard” frequency characteristics.
Front Reference : Adjusts the characteristics of all of the speakers to match the
characteristics of the front speaker.
Off
Note
This function does not work when [2ch Analog Direct] is being used.
The receiver may play signals at a lower sampling frequency than the actual sampling
frequency of the input signals, depending on the audio format.
[65] Adjusting Settings
Speaker Setup
Selecting the speaker pattern (Speaker Pattern)
You can select the speaker pattern according to the speaker system which you are using.
1. Select [Setup] - [Speaker Setup] from the home menu.
2. Select [Speaker Pattern].
To Next Page
Loading...
Need help?
General
