The sound fields for movie may not work, depending on the input or the speaker pattern
you select, or with audio formats.
The receiver may play signals at a lower sampling frequency than the actual sampling
frequency of the input signals, depending on the audio format.
[Pro Logic IIx] may not appear, depending on the speaker pattern you select.
Some speakers or the subwoofer may not output sound, depending on the sound field
setting.
If there is any noise present, the noise may be different, depending on the sound field you
select.
Hint
You can also select [Sound Field] in [Sound Effects] from the home menu.
You can also use 2CH/A.DIRECT, A.F.D., MOVIE or MULTI ST. on the remote control or
the receiver to select a sound field.
[32] Enjoying Video and Sound
Enjoying sound effects
Resetting sound fields to the default settings
Be sure to use the buttons on the receiver to perform this operation.
1. Turn off the receiver.
2. Hold down MULTI ST. and press (on/standby) on the receiver.
[S.F. INITIALIZED!] appears on the display panel and all sound fields are reset to their
default setting.
[33] Enjoying Video and Sound Enjoying sound effects
Adjusting the equalizer (Equalizer)
You can use the following parameters to adjust the tonal quality (bass/treble level) of the
front, center, surround/surround back and front high speakers.
To Next Page
Loading...
Need help?
General
