Space remains between the plug and the rear panel even when the power cord (mains lead) is
inserted firmly. The cord is supposed to be connected this way. This is not malfunction.
2. Press (on/standby) to turn on the receiver.
You can also turn on the receiver using MAIN (on/standby) on the remote control.
To turn off the receiver, press MAIN (on/standby) again.
Note
After you turn off the receiver, [STANDBY] flashes on the display panel. Do not
disconnect the AC power cord (mains lead) while [STANDBY] is flashing. This may cause
a malfunction.
[24] Preparation
Initial setup of the receiver
Setting up the receiver using the Easy Setup
When you turn on the receiver for the first time or after the receiver is initialized, the Easy
Setup screen appears on the TV screen. You can set up the following settings for the
receiver by following the instructions on the Easy Setup screen.
Auto Calibration
Perform automatic calibration in accordance with your speaker system configuration and
arrangement.
Internet Setup
Configure settings to connect the receiver to the network.
Note
Switch the input of the TV to the input to which the receiver is connected to use this
function.
If the Easy Setup screen does not appear or you want to display the Easy Setup screen
To Next Page
Need help?
General
