[99] Adjusting Settings Zone Setup
Presetting the volume in the main zone (Main Preset
Volume)
Set the volume to be used when the receiver is turned on.
1. Select [Setup] - [Zone Setup] from the home menu.
2. Select [Main Preset Volume].
3. Adjust the volume.
[100] Adjusting Settings Zone Setup
Turning on/off the power for zone 2/3 (Power)
You can turn on or off the power for zone 2 or zone 3 by the following procedure.
1. Press ZONE2 or ZONE3 on the remote control or on the receiver.
Note
The receiver in zone 2 or zone 3 remains turned on even when this receiver is in standby
mode (To turn off the amplifier power for zone 2 or zone 3, press ZONE2 or ZONE3 on
the remote control or on the receiver.).
When the receiver is in standby mode, the (on/standby) indicator on the front panel
lights up in amber if the receiver in zone 2 or zone 3 is turned on.
The top of the cabinet may become hot. This is because part of the circuit(s) inside the
receiver is(are) still turned on, and is not a malfunction.
Hint
You can also turn on or off the power for zone 2 or zone 3 by setting [Zone2 Power] or
[Zone3 Power] in [Zone Setup] from the home menu.
[101] Adjusting Settings
Zone Setup
Selecting the source signals for zone 2/3 (Input)
To Next Page
Loading...
Need help?
General
