1-38 (E)
VPL-FHZ55
1-7. Procedure When IR Receiver Reduced Sensitivity
When this unit is under the specifi ed environment, the IR receiver on the front of this unit may be reduced
sensitivity. In this case, perform the procedure below.
1-7-1. Tools
. SHEET (IR): 4-284-029-01
1-7-2. Procedure
1. Remove the holder (LED). (Refer to steps 1 and 2 in Section 1-4-20.)
2. Insert the sheet (IR) between holder (LED) and NF board, then fi x them using the nylon rivet.
n
When installing the sheet (IR), orient the holes as shown in the fi gure.
3. Assemble this unit by reversing the removal procedure.
1-7-3. Procedure after Installing
1. Turn on the power of this unit, then display the menu.
2. Select the menus in the following order: “The Operation Menu” → “IR Receiver” → “Front”.
3. Operate the remote controller from front side of this unit, then check this unit is operated properly.
4. Return the “IR Receiver” changed in step 2 to the original setting.
5. Turn off the power of this unit.
Nylon rivet
Holder (LED)
Sheet (IR)
Sheet (IR)
Orient the holes.
NF board
NF board