2-18 (E)
VPL-FHZ55
2-6-5. Writing of C Board/Opt Unit/3DGamma/LookUpTable/Chiral/GCFB Data
1. Connect the power cord and set this unit to standby state.
2. Press the I/O button on this unit.
The lamp lights and the image is displayed.
3. Double-click QuickAccess2.exe to start the application.
4. Select a target model on the Model pull-down menu.
5. Select Load on the Load/Save pull-down menu.
6 Select the data type (C Board/Opt Unit/3DGamma/LookUpTable/Chiral/GCFB) on the Data Type
pull-down menu.
7. Click the [Next] button.
8. Click the [Browse...] button.
The file selection window is displayed.
9. Select the file to be written.
10. Click the [Next] button.
11. Select the serial port used for connecting PC on the Serial Port pull-down menu.
Upper line: Serial port number used for connecting PC
Lower line: 38400
12. Click the [Next] button.
The window displaying the file path, model name written in file, unit serial, serial number, model
name of this unit, and serial number is displayed.
13. Click the [OK] button.
The writing starts. Completed is displayed after completed.
14. Press the I/O button and set this unit to standby state.
15. Disconnect the power cord.
16. Click the [Complete] button.