322
Creating and Saving a
Master Timeline
You can save region information (information on any
regions, including the register numbers associated with the
regions) referred to as a master timeline in a dedicated
register. By recalling that register, you can manipulate the
regions and registers together.
Creating and Saving a Master
Timeline (Numeric Keypad Control
Block)
Creating and saving a master timeline
1
Press the [EFF] button.
The control block switches to effect operation mode,
and the [EFF] button and [RCALL] button light
amber.
2
Recall the effect to save on the master timeline by
specifying the register number for each region.
For details about the method of operation, see
“Recalling a register” (page 307).
3
Press the buttons for the regions you want to save on
the master timeline, turning them on.
4
Press the region selection button [MASTR], turning it
on.
The display shows “MASTR” and the last recalled
master timeline register number.
5
Press the [STORE] button, turning it on.
6
With the numeric keypad buttons, enter the number of
the register in which you want to save the master
timeline.
For details about selecting a register, see “Register
selection in the numeric keypad control block”
(page 306).
7
Press the [ENTER] button.
This saves the effect in the specified register.
The [RCALL] button and the [STORE STATS] button
light amber.
• It is not possible to undo a master timeline save.
• Saving the master timeline does not carry out a save of
effects. Save the effects for each region first, then carry
out the master timeline save.
Modifying a master timeline
This section describes changing the M/E-1 register from
Effect 5 to Effect 10 as an example.
Example: Master timeline register information before and
after modification
1
Recall the master timeline register you want to change
(see page 307)
.
This simultaneously recalls M/E-1 register 5 and P/P
register 5, and the [M/E1] and [P/P] region selection
buttons light.
2
Press the region selection button [MASTR], turning it
off.
3
Turn on only the button for the region you want to
change ([M/E1]), and recall the desired register (Effect
10).
This recalls M/E-1 register 10, while on P/P register 5
remains selected.
4
Press the buttons for the regions you want to save on
the master timeline ([M/E1] and [P/P]), turning them
on.
5
Press the region selection button [MASTR], turning it
on.
The display shows the last recalled master timeline
register number.
6
Press the [STORE] button, turning it on.
7
Use the numeric keypad buttons to enter the number of
the register in which you want to save the master
timeline, and press the [ENTER] button.
This saves M/E-1 register 10 and P/P register 5 in the
master timeline register.
Notes
Region Register
Before
modification
After modification
M/E-1 Effect 5 Effect 10
P/P Effect 5 Effect 5
To Next Page
Loading...
Need help?
General
