329
Yes: Available, No: Not available
Attribute display
You can check the attributes added to a snapshot in the
Snapshot menu (see page 335)
.
Temporary attributes
When recalling a snapshot, you can temporarily enable
attributes distinct from the attributes set for each register.
These are called “temporary attributes.”
You set temporary attributes when recalling a snapshot.
Bus override
If you recall a snapshot while holding down an A or B bus
button, the selection of the signal on the A or B bus does
not change when the snapshot is recalled. This function is
called “bus override.”
This function is effective when cross-point hold is not set,
and you want to temporarily maintain the cross-point
setting. When cross-point hold is set, bus override
operation is not necessary.
Snapshot Operations
(Numeric Keypad Control
Block)
Saving and Recalling Snapshots
Numeric keypad control block
Saving a snapshot
1
Set the state you want to save as a snapshot.
2
In the numeric keypad control block, press the
[SNAPSHOT] button.
The control block switches to snapshot operation
mode, and the [SNAPSHOT] button and [RCALL]
button light amber.
3
Use the region selection buttons to select the target
region of the operation.
You can select more than one button.
The following region selection buttons can be operated
for snapshots.
Attributes Region
M/E-1,
M/E-2,
M/E-3,
M/E-4,
M/E-5,
PGM/PST
User1 to
8
DME ch1
to ch4
Cross-point hold Ye s Ye s Ye s
Key disable Ye s No N o
Effect dissolve Ye s Ye s Yes
Auto transition Ye s N o N o
Clip auto play No Yes No
SNAPSHOT button
EFF DISS button
UNDO button
STORE STATS button
Display
AUTO TRANS button
Numeric keypad buttons
RCALL button
Region selection buttons
STORE button
To Next Page
Loading...
Need help?
General
