343
The status area shows the information for the selected
shotbox register and the key selection buttons.
3
In the status area, select a switcher bank.
To select all switcher banks, press [ALL].
4
Press a key selection button to select a key.
You can select more than one key.
5
Press [Key SS Assign], turning it on, and select a
register to register using the following parameter.
The key selection button shows the selected register
number (KSS1 to KSS4).
6
Repeat steps 3 to 5 as required to set all key snapshots
to be registered in the shotbox register.
7
In the <Store> group, press [Store].
To return to the state before saving the setting
In the <Store> group, press [Undo].
Recalling a shotbox register
1
In the Shotbox >Register >Store/Recall menu (6411),
select a register.
2
Press [Recall].
If auto run is set for the register, the effects are
executed at the same time the register is recalled.
Shotbox Execution
You can execute a shotbox using the numeric keypad
control block, Flexi Pad control block, utility/shotbox
control block, or cross-point control block.
Shotbox Execution (Numeric Keypad
Control Block)
Numeric keypad control block
1
In the numeric keypad control block, press the
[SHOTBOX] button.
The control block switches to shotbox operation mode,
and the [SHOTBOX] button and [RCALL] button
light amber.
The display shows the last recalled register number.
2
Enter the register number to recall using the numeric
keypad buttons.
For details about selecting a register, see “Register
selection in the numeric keypad control block”
(page 306).
3
Press the [ENTER] button.
The selected shotbox register is executed.
If auto run is set, the effects are executed at the same
time they are recalled.
The region selection buttons corresponding to the
regions for which effects are set turn on.
No. Parameter Adjustment
3Key
Snapshot
Key snapshot register number
SHOTBOX button
Numeric keypad buttons
Display
RCALL button
Region selection buttons
To Next Page
Loading...
Need help?
General
