– 3 –
ENGLISH
1-1. Choosing a place for the printer
Before actually unpacking the printer, you should take a few minutes to
think about where you plan to use it. Remember the following points
when doing this.
✓ Choose a firm, level surface where the printer will not be exposed to
vibration.
✓ The power outlet you plan to connect to for power should be nearby
and unobstructed.
✓ Make sure that the printer is close enough to your host computer for
you to connect the two.
✓ Make sure that the printer is not exposed to direct sunlight.
✓ Make sure that the printer is well away from heaters and other sources
of extreme heat.
✓ Make sure that the surrounding area is clean, dry, and free of dust.
✓ Make sure that the printer is connected to a reliable power outlet. It
should not be on the same electric circuit as copiers, refrigerators, or
other appliances that cause power spikes.
✓ Make sure that the room where you are using the printer is not too
humid.
1-2. Mounting hardware for wall mount model
Precautions when mounting
✓ Unplug the power cord from the outlet before starting any of the
following operations.
✓ Select a location where the unit will not be exposed to water or impact.
Make sure the wall material has sufficient width for mounting the
brackets.
✓ Carefully select screws for mounting the bracket to the wall. These
screws must have sufficient strength to hold the printer and must be
long enough to enter the wall and provide a secure mounting.
Remember that we will in no way be responsible for damage resulting
from the printer falling due to insufficient mounting strength.
✓ The weight of the printer, including a roll of paper with the largest
diameter, is approximately 2.9 kg.
✓ The screws for mounting the bracket must have both a shear and
tensile strength capable of withstanding a load of 12 kgf (118 N) or
more. It is recommended that anchor nuts be used.
✓ A screw diameter of 4 mm is recommended.
To Next Page
Loading...
Need help?
General
