MAINTENANCE MANUAL
STEMME TSA-M
MAINTENANCE MANUAL
STEMME TSA-M
10-11-00
Page 201
STORAGE
1. Storage - up to 30 Days
A. The following guidelines are applicable for situations in which the aircraft is not to be used for
periods of time between 7 and 30 Days. They are meant to help prevent deterioration of the
aircraft during periods of non-use.
(1) To prepare the engine for storage, check for correct oil level and add oil if necessary to bring
the level to the full mark. Then, run the engine for at least five minutes at 1700 to 2000 RPM
with oil and cylinder heat temperatures in the normal operating range. Shut down the
engine.
(2) Top up the fuel tanks to prevent condensation of water in the tanks.
(3) Install covers over the cabin area to keep out moisture and sunlight. Install Pitot tube cover.
To prevent oxidation of the finish, the use of covers over the composite fuselage during
extended periods of outdoor tie-down, especially in summer time, is recommended.
WARNING: BEFORE ROTATING THE PROPELLER BLADES, MAKE CERTAIN THAT THE
IGNITION SWITCH IS OFF AND THE THROTTLE IS CLOSED.
(4) After every seven days during storage, rotate the propeller by hand. After rotating the
engine six revolutions, stop the propeller 60° to 120° from its former position.
(5) If, at the end of 30 days, the aircraft will not be removed from storage, the engine should be
started and run in a safe area. The preferred method is to fly the aircraft for at least 30
minutes.
2. Storage with a Duration up to 90 Days
A. For storage periods not to exceed 90 days, the following methods of treatment are required:
(1). Fuel system
(a) The fuel tanks must be filled completely with correct grade fuel.
(2) Engine
(a) Consult the ROTAX Operator's Manual for engine preservation recommendations for
the installed engine.
(3) Electrical System
(a) Remove battery and store in a cool, dry room. Perform service as described in chapter
12 "Ground services".
(b) Cover or mask any disconnected electrical leads to protect against corrosion.
(4) Airframe
(a) Clean aircraft inside and outside. Remove any oil or grease from surfaces.
(b) Wax aircraft thoroughly.
Nov 18/11
To Next Page
Loading...
Need help?
General
