WORKSHOP MANUAL
1 - INTRODUCTION
EDITION
PAGE
3 /37
Despite the efforts made to ensure accuracy in the realisation of this manual, errors and inac-
curacies may be found in the content. The author is not responsible for any missing or incorrect
information.
The Manufacturer reserves the right to make any modifications to the product without warning or
any obligation to promptly update this manual.
The introduction of new procedures or indications in addition to those contained in this Manual are
reported to the Service Centres by means of ad hoc bulletins and press releases.
All information contained herein is based on data available at the time of publication.
The drawings and photos included herein, may not correspond exactly to the machine on which
the intervention is required.
The manual is divided into chapters, paragraphs and sub-paragraphs.
• The front inside cover provides the table of contents indicating the various chapters.
• Each chapter is dedicated to a specific topic, and is preceded by an index that marks the various
paragraphs contained therein.
• Each paragraph is further divided into sub-paragraphs, relative to a single procedure.
Cross-references to other parts of the manual are indicated by the symbol
followed by the
relevant chapter, paragraph or sub-paragraph number.
1.1 HOW TO USE THE GUIDE ..........................................................................3
1.1.1 Limitation of Responsibility .....................................................................3
1.1.2 Structure of the Manual ..........................................................................3
1.1.3 Symbols and Definitions used ................................................................4
1.2 WORK SAFETY INSTRUCTIONS ............................................................... 5
1.2.1 Qualification of operators .......................................................................5
1.2.2 Preparing to work ...................................................................................5
1.2.3 Precautions during servicing ..................................................................5
1.3 SERVICE CENTRE PROCEDURES ...........................................................5
1.3.1 Equipment registration ........................................................................... 5
1.3.2 Interventions under Warranty..................................................................6
1.3.3 Exceptions to the use of the Warranty ....................................................6
1.3.4 Service repairs outside warranty ............................................................ 6
1.3.5 Fault notification .....................................................................................6
1.3.6 Spare parts requests ..............................................................................6
To Next Page
Loading...
Need help?
General
