FORESTER NA. (E)
10-46
Main fuse and fusible link
HS0203
The main fuses and fusible link are designed to melt during an overload
to prevent damage to the wiring harness and electrical equipment.
Check the main fuses and fusible link if any electrical component fails to
operate (except the starter motor) and other fuses are good. A melted
main fuse or fusible link must be replaced. Use only replacements with
the same specified rating as the melted main fuse or fusible link. If a
main fuse or fusible link blows after it is replaced, have the electrical sys-
tem checked by your nearest SUBARU dealer.
Installation of accessories
Always consult your SUBARU dealer before installing fog lights or any
other electrical equipment in your vehicle. Such accessories may cause
the electronic system to malfunction if they are incorrectly installed or if
they are not suited for the vehicle.
Checking the headlight aim
Before checking the headlight aim:
1. Set the light switch to the OFF position. Be sure that the area around
the headlights has not sustained any accident damage or other type of
deformation.
2. Park the vehicle on level ground and remove any heavy objects from
To Next Page
Loading...
Need help?
General
