42
step 2 Register an account. Refer to "7.3 Account Registration". If you have got the account and
password from the distributor/installer or SUNGROW, skip this step.
step 3 Download the firmware package to the mobile device in advance. Refer to “Firmware Upa-
date”. This is to avoid download failure due to poor on-site network signal.
- - End
6.4 Creating a Plant
Prerequisites:
• The account and password for logging in to iSolarCloud App have been obtained from
the distributor/installer or SUNGROW.
• The communication device is normally connected to the inverter.
• System positioning is enabled and iSolarCloud App is allowed to access location
information.
step 1 Open the App, tap
in the upper right corner of the interface, and select the correct ac-
cess address.
figure 6-1 Select Access Address
step 2 Enter the account and password on the login interface, and tap LOGIN to log in.
step 3 Tap
in the upper right corner to enter the plant creation interface.
6 Commissioning User Manual
To Next Page
Loading...
Need help?
General
