Suzuki 2004 VL800 User Manual

INSTALLATION
CAUTION
A crossthreaded or overtight-
ened spark plug wil damage
the aluminum threads of the
cylinder head.
Carefully turn the spark plug by
hand into the threads until it is fin-
ger tight. If the spark plug is new,
tighten it with a wrench about 1/2
turn past finger tight. If you are
reusing the old spark plug, tighten
it with a wrench about 1/8 turn
past finger tight.
CAUTION
Dirt can damage your engine if
it enters an open spark plug
hole.
Cover the spark plug hole
whenever the spark plug is
removed.
ENGINE OIL
Engine life depends on oil amount
and quality. Daily engine oil level
checks and periodic changes are
two of the most important mainte-
nance items to be performed.
Engine Oil Level Check
Follow the procedure below to
inspect the engine oil
leveL.
1. Start the engine and allow it to
idle for a few minutes.
2. Stop the engine and wait
approximately three minutes.
3. Hold the motorcycle vertically
and inspect the engine oil
level
through the engine oil level
inspection window. The engine
oil level should be between "L"
(low) and "F" (full) lines.
52

Suzuki 2004 VL800 Specifications

General

Manufacturer	Suzuki
Model	VL800
Year	2004
Displacement	805 cc
Bore x Stroke	83.0 mm x 74.4 mm
Compression Ratio	9.4:1
Ignition	Electronic ignition (transistorized)
Transmission	5-speed constant mesh
Final Drive	Shaft drive
Front Suspension	Telescopic, coil spring, oil damped
Front Brakes	Single disc brake
Rear Brakes	Drum brake
Front Tire	130/90-16
Rear Tire	170/80-15
Seat Height	700 mm (27.6 in)
Ground Clearance	140 mm (5.5 in)
Engine Type	4-stroke, liquid-cooled, 45° V-twin
Rear Suspension	oil damped
Overall Width	985 mm
Wheelbase	1, 655 mm
Curb Weight	246 kg
Category	Cruiser