6-30
INSPECTION AND MAINTENANCE
52SS0-01E
52SS60430
2) Loosen the nuts (3) and then remove
the bracket (4).
3) Disconnect the negative cable (5).
4) Disconnect the positive cable (6).
To install the battery:
Install the battery in the reverse order of
removal.
NOTE:
• When the battery is disconnected, some
of the vehicle’s functions will be initial-
ized and/or deactivated.
These functions must be required to
reset after the battery is reconnected.
• Do not disconnect the battery terminals
for at least one minute after the ignition
switch is turned off.
Battery label
52SS60440
(7) Crossed-out wheeled bin symbol
(8) Chemical symbol of “Pb”
The crossed-out wheeled bin symbol (7)
located on the battery label indicates that
the used battery should be collected sepa-
rately from ordinary household trash. The
chemical symbol of “Pb” (8) indicates the
battery contains more than 0.004% lead.
By ensuring the used battery is disposed
of or recycled correctly, you will help pre-
vent potential negative consequences for
the environment and human health, which
could otherwise be caused by inappropri-
ate trash handling of the battery. The recy-
cling of materials will help to conserve
natural resources. For more detailed infor-
mation about disposing of or recycling the
used battery, consult a SUZUKI dealer.
WARNING
Batteries contain toxic substances
including sulfuric acid and lead. They
could have potential negative conse-
quences for the environment and
human health. Used batteries must
be disposed of or recycled according
to applicable rules or regulations and
must not be disposed of with ordi-
nary household trash. Make sure not
to tip over the battery when you
remove it from the vehicle. Other-
wise, sulfuric acid could run out and
you might get injury.
NOTICE
After stopping the engine, controller
and system are operated for a while.
Therefore, before removing the bat-
tery, wait for more than one minute
after turning the ignition switch to
“OFF”.
Pb
(7)
(8)
To Next Page
Loading...
General