6-36
INSPECTION AND MAINTENANCE
52SS0-01E
Headlight Aiming
Since special procedures are required, ask
a SUZUKI dealer or a qualified workshop
for this job.
Bulb Replacement
Headlight
52SS6004E
1) Open the driver’s or passenger’s door,
loosen the screws (1) and then remove
the light housing.
CAUTION
• Light bulbs can be hot enough to
burn your finger right after turning
off lights. This is true especially for
halogen headlight bulbs. Replace
the bulbs after they become cool
enough.
• The headlight bulbs are filled with
pressurized halogen gas. They can
burst and injure you if they are hit
or dropped. Handle them carefully.
• To avoid injury by sharp-edged
parts of the body, wear gloves and
a long-sleeved shirt when replacing
light bulbs.
NOTICE
• The oils from your skin may cause
a halogen bulb to overheat and
burst when the lights are on. Grasp
a new bulb with a clean cloth.
• Frequent bulb replacement indi-
cates the need for an inspection of
the electrical system. This should
be carried out by a SUZUKI dealer
or a qualified workshop.
To Next Page
Loading...
General