2-20
BEFORE DRIVING
52SS0-01E
How to use the setting mode:
1) When the ignition switch is in “ON”
position and the vehicle is stationary,
push the trip meter selector knob (2) to
switch the information display indication
to the odometer.
2) Push and hold the trip meter selector
knob (2) until the display shows
“”.
3) Push the trip meter selector knob (2) to
select a function that you want to set up
according to the chart in the previous
page.
4) Push and hold the trip meter selector
knob (2) to register settings of the fol-
lowing functions.
52SS2015E
(a) Comfort Mode setting indication
(default setting)
(b) Load Mode setting indication
(c) Back indication
NOTE:
• As shown in the illustration, “ ” and
“ ” indicates on the display of currently
setting item.
• To go back to the higher level display
during operation, push the trip meter
selector knob (2) to display “ ” or
“ ” and then push and hold the trip
meter selector knob (2).
Tyre pressure monitoring system set-
ting “ ”:
• : Comfort Mode (default set-
ting)
• : Load Mode
Refer to “Tyre Pressure Monitoring System
(TPMS) (if equipped)” in “OPERATING
YOUR VEHICLE” section for details.
Initialization setting “ ”:
• : Initialize all settings
How to exit the setting mode:
Switch the display to show “ ” and then
push and hold the trip meter selector knob
(2).
Lighting Control Lever
55S20025
WARNING
To avoid possible injury, do not oper-
ate controls by reaching through the
steering wheel.
To Next Page
Loading...
General