17
STEERING TENSION ADJUSTMENT
The steering on your outboard motor should be
smooth and not too tight. Adjust the steering
tension so that there is only a slight resistance
to steering movement. To increase the steering
tension, turn the steering tension adjuster A
clockwise. To decrease the steering tension,
turn the steering tension adjuster counterclock-
wise.
THROTTLE TENSION ADJUSTMENT
The tension of the throttle control grip can be
adjusted according to your preference. To
increase the tension, turn the throttle tension
adjuster A clockwise. To decrease the tension,
turn the adjuster counterclockwise.
WARNING
If you operate the motor with the tilt pin
removed, you may not be able to control
steering as expected.
Do not operate the motor with the tilt pin
removed.
IDLE SPEED ADJUSTMENT
The idle speed of your outboard motor has
been set by your dealer. If it is necessary to
adjust the idle speed, use the following proce-
dure:
1. Warm up the engine for about 5 minutes.
2. Make sure that the motor is in “NEUTRAL”
and the throttle control grip is fully closed.
3. Turn the idle adjustment screw A clockwise
to increase idle speed or counterclockwise
to decrease idle speed.
NOTE:
If idle speed cannot be set within the specified
range, contact your authorized Suzuki Marine
Dealer.
Idle speed
(in Neutral)
DF4A
1250 – 1350
r/min. (min
–1
)
DF6A
To Next Page
Loading...
Need help?
General
