Suzuki DF4A User Manual

53
After operation in muddy, brackish, or salt
water, you should flush the water passages and
motor surface with clean, fresh water. If you do
not flush the water passages, salt can corrode
the motor and shorten its life.
1. Make sure that the motor is stopped.
2. Shift the motor into “NEUTRAL”.
3. Remove the propeller from the motor. Refer
to the PROPELLER SELECTION AND
INSTALLATION section.
4. Install the motor on a large container such
as an empty 55 gallon drum.
5. Fill the container with clean, fresh water as
illustrated.
6. Start the motor and let it idle for about five
minutes. This will clean the salt water out of
the cooling system.
7. Shut off the motor. Remove the motor from
the container and maintain motor in a verti-
cal position until the engine has drained
completely. Reinstall the propeller as out-
lined in the PROPELLER SELECTION AND
INSTALLATION section.
8. Clean the motor surface and apply a coat of
automotive wax on the external finish of the
motor.
ENGINE NOT RUNNING – Vertical
position –
To flush the water passages, you must obtain
an optional flushing attachment from your
authorized Suzuki Marine Dealer.
1. Make sure that the motor is stopped.
2. Remove the flush plug and install the flush-
ing attachment 1.
3. Connect a garden hose to the flushing
attachment.
4. Turn on the water to obtain a good water
flow. Flush the engine for about five minutes.
5. Turn off the water.
6. Remove the hose and flushing attachment
then reinstall the plug into the flushing port.
7. Leave the motor in a vertical position until
the engine is drained completely.
ENGINE NOT RUNNING – Full tilt up
position –
1. Raise the engine to the full tilt up position.
2. Follow the “ENGINE NOT RUNNING – Verti-
cal position” instructions.
DO NOT RUN ENGINE IN THE FULL TILT
UP POSITION.
3. Lower the motor to a vertical position until
the engine is drained completely.

Suzuki DF4A Specifications

General

Brand	Suzuki
Model	DF4A
Category	Outboard Motor
Language	English