Suzuki GS500E User Manual

19-28 GS500K3 (’03-MODEL)
WIRE ROUTING
Clamp
Clamp
Clamp
Clamp
Clamp
No slack
Starter relay
Air cleaner box
Clamp
Clamp
Clamp
Side stand switch
Pass the lead wire
underneath the frame.
Make clearance
between the wiring
harness and fuel
tank bracket.
Make clearance between the helmet
holder and wiring harness.
Pass the turn signal
light lead wire between
the frame and rear fender.
No slack.
Clamp
Clamp
Clamp
Clamp
Ignition coil, left
Ignition coil, right
Spark plug cap
Ignition coil lead wire
Clutch cable
Throttle cable
Wiring harness
Neutral switch lead wire
Regulator lead wire
Clamp the wiring harness at
bule tape on the wiring harness.
Regulator
Side stand relay
Turn signal relay
Side stand switch
coupler must be located
over the starter relay
coupler.
Rear brake light switch
Solenoid
TPS
A
B
Pass the combination
meter lead wire above
the handlebar switch
lead wires.
Pass the solenoid lead wire
between the air cleaner box
and solenoid.

Suzuki GS500E Specifications

General

Brand	Suzuki
Model	GS500E
Category	Motorcycle
Language	English