FRONT AND REAR BRAKES 15-5
BRAKE PADS REPLACEMENT
FRONT BRAKE PADS
• Remove the cap 1 and pad mounting pin 2.
• Remove the brake pads.
NOTE:
Replace the two brake pads as a set.
• Fit the new brake pads into the caliper.
• Tighten the pad mounting pin to the specified torque.
Brake pad mounting pin: 18 N·m (1.8 kgf-m, 13.0 lb-ft)
NOTE:
Pump the brake lever several times to seat the brake pads after
reassembling.
REAR BRAKE PADS
• Remove the pad mounting pin 1.
• Remove the brake pads.
NOTE:
Replace the two pads as a set.
To Next Page
Loading...
Need help?
General
