5
Tighten the handlebar clamp bolts to the specified
torque.
"
""
" Handlebar clamp bolt: 26 N·m (2.6 kgf-m)
A: 8 × 35 mm flange bolt
B: 8 × 35 mm flange bolt
C: Dot mark
D: Punch mark
1. Lift the front of motorcycle by using a hoist.
2. Raise the rear of motorcycle.
3. Pull the crate base forward, then balance the
motorcycle.
FRONT FORK
Insert each fork leg assembly into the lower and upper
brackets.
Adjust the line of front fork to the top face of the upper
bracket and air valve is positioned at the front.
A: Caliper
B: Right fork leg
C: Left fork leg
D: Line
E: Front fork upper bracket
F: Air pressure
NOTE:
To install the handlebars correctly, first tighten
the bolt A
AA
A of the front side with specified
torque and then tighten the bolt B
BB
B of the rear
side.
Make sure that the clamp has no clearance at
the front side as shown in the illustration.
FRONT
Keep the position of front brake master cylinder
with its cap facing upwards until it is installed.
Install the front fork assembly with front brake
caliper to the left side.
To Next Page
Loading...
Need help?
General
