7
#
A: Clutch cable
B: Throttle cable
C: Front brake hose
D: Engine stop switch wiring harness
FRONT BRAKE MASTER CYLINDER
Remove the bolts and holder from the front brake mas-
ter cylinder.
Install the front brake master cylinder onto the handle-
bars.
Align the dot mark on the handlebars with the master
cylinder-to-holder fitting surface.
Tighten the master cylinder mounting bolts to the
specified torque.
"
""
" Front brake master cylinder mounting bolt:
10 N·m (1.0 kgf-m)
A: Holder
B: Front brake master cylinder
C: Flange bolt
D: Flange bolt
E: Dot mark
A: Bolt
B: Holder
C: Front brake master cylinder
D: Handlebars
The line drawings on page 25 and 26 show the
proper routing of the control cables, hose and
wirings.
Refer to them in addition to following the
instructions carefully.
NOTE:
To install the holder correctly, first tighten the
bolt C
CC
C of the upper side with specified torque
and then tighten the bolt D
DD
D of the lower side.
NOTE:
Install the holder in position according to the
mark “UP”.
Make sure that the holder has no clearance at
the upper side as shown.
Check for brake fluid leakage.
To Next Page
Loading...
Need help?
General
