14. Brake System
14-4
Disk Brake System Inspection
Inspection
Examine for leaking or damage visually.
Inspect brake tube seam with spanner to check if
it becomes loose.
Checking if there is any interferes, contacts
between protected pipeline and other parts by
turning the handle bar right or left, pressing the
cushion up and down.
Remove the front brake pad cap.
Check the brake wear from the brake caliper.
The brake pad must be replaced with new lining
when it reaches the wear limit.
Park the motorcycle on an even ground, and
check if fluid level is under the “LOWER” mark.
Recommended Brake Fluid: WELL RUN BRAKE
OIL (DOT 3).
Caution
Inclined or just stopped vehicles could not be
measured oil level accurately. For accuracy,
vehicles should stay in still position for 3-to
minutes.
In order to prevent chemical change, please do
not use counterfeiting or other uncertified brake
fluid.
Please use the same brand of brake fluid
consistently for brake efficiency.
Brake linings wear limit
grooves
To Next Page
Loading...
Need help?
General
