17. Electrical System
17-2
Precautions in Operation
When removing the battery, the disconnection sequence of cable terminals shall be strictly observed.
(First disconnect the negative cable terminal, next, the positive cable terminal.)
The model of the spark plug and the tightening torque.
The ignition timing.
Adjustment of headlight.
Removal and installation of AC generator.
The maintenance-free battery requires no inspection of electrolyte level and refilling of distilled water.
To recharge the battery, remove the battery from rack without removing ventilation caps.
Unless in emergency, never rapid-charge the battery.
The voltage must be checked with the voltmeter while charging the battery.
As ECU assembly does not require an ignition timing check. In case ignition timing is incorrect, check
ECU and AC generator. Verify with an ignition timing light after replacement if necessary.
Specification
Charging system
1.2A / 5~10hr (standard) 5A / 1hr (rapid charging)
Control voltage in charging
Ignition system
Ignition coil and
resistance
Crankshaft position sensor resistance (20℃)
To Next Page
Loading...
Need help?
General
