TECO JSDAP-75A3 User Manual

5-44
5-4-7 Clear the Pulse Offset
In position control mode, parameter Pn315 (Pulse Error clear mode) has three modes can be select.
CLR input contact is used to clear the pulse error as required according to the list below.
Parameter Name Setting Description
Control
Mode
0
When Input CLR contact, clears the pulse error
value.
Pe
1
When Input CLR contact to cancels the position
command, Stops the motor rotating, the pulse error
value is cleared and mechanical Home signal is
reset.
Pi
Pe
Pn315
Pulse Error Clear
Mode
2
When Input CLR contact to cancels the position
command, stops the motor rotating and the pulse
error value is cleared.
Pi
Note: Input contacts status “1” (ON) and “0” (OFF)
Please check 5-6-1 to set the required high /Low signal levels (PNP/NPN) selection.

TECO JSDAP-75A3 Specifications

General

Brand	TECO
Model	JSDAP-75A3
Category	Servo Drives
Language	English