Section 1—2215A Service
SPECIFICATION
INTRODUCTION
The TEKTRONIX 2215A Oscilloscope is a rugged, light
weight, dual-channel, 60-MHz instrument that features a
bright, sharply defined trace on an 80- by 100-mm cathode-
ray tube (crt). Its vertical system provides calibrated deflec
tion factors from 2 mV per division to 5 V per division.
Trigger circuits enable stable triggering over the full band
width of the vertical system. The horizontal system provides
calibrated sweep speeds from 0.5 s per division to 50 ns per
division along with delayed-sweep features. A X I0 magnifier
circuit extends the maximum sweep speed to 5 ns per divi
sion when the A and B SEC/DIV switch is set to 0.05
ns
per
division.
ACCESSORIES
The instrument is shipped with the following standard
accessories:
1 Operators Manual
2 Probe packages
1 Power Cord
For part numbers and information about instrument ac
cessories, refer to the tabbed "Accessories” part of the Re
placeable Mechanical Parts section in the back of this
manual.
The service manual and all other optional accessories are
orderable from Tektronix, Inc. A local Tektronix Field Office,
representative, or the Tektronix product catalog can provide
ordering and product information.
PERFORMANCE CONDITIONS
The following electrical characteristics (Table 1-1) are
valid for the 2215A when it has been adjusted at an ambient
temperature between + 20°C and +30°C, has had a warm
up period of at least 20 minutes, and is operating at an
ambient temperature between 0°C and +50°C (unless oth
erwise noted).
Items listed in the “Performance Requirements" column
are verifiable qualitative or quantitative limits, while items
listed in the “Supplemental Information” column are either
explanatory notes, calibration setup descriptions, perfor
mance characteristics for which no absolute limits are speci
fied, or characteristics that are impractical to check.
1-1
To Next Page
Loading...
Need help?
General
