Tektronix 2215A User Manual

Adjustment Procedure—2215A Service
INDEX TO ADJUSTMENT PROCEDURE
STEPS
Power Supply and CRT Display Page
1. Check/Adjust Power Supply DC Levels ............. 5-4
2. Check High-Voltage Supply .................................. 5-5
3. Adjust CRT Grid Bias .......................................... 5-5
4. Adjust Astigmatism .............................................. 5-5
5. Adjust Trace Alignment ........................................ 5-5
6. Adjust Geometry ................................................... 5-5
Vertical
1. Adjust Attenuator Step Balance .......................... 5-6
2. Adjust 2/5 mV DC Balance .................................. 5-6
3. Adjust Channel 1 Variable Balance...................... 5-7
4. Adjust Channel 2 Invert Balance.......................... 5-7
5. Adjust MF/LF Compensation and Gain Balance . 5-7
6. Adjust Vertical Gain .............................................. 5-8
7. Check Deflection Accuracy and Variable Range . 5-8
8. Check Input Coupling ........................................... 5-8
9. Adjust Attenuator Compensation ........................ 5-9
10. Check Alternation Operation ................................ 5-10
11. Check Chop Operation ......................................... 5-10
12. Adjust High-Frequency Compensation and
Delay Line Compensation .................................... 5-10
13. Check Bandwidth Limit Operation .................... 5-11
14. Check Bandwidth ............................................... 5-11
15. Check Channel Isolation ..................................... 5-11
16. Check Common-Mode Rejection R atio ............... 5-12
17. Check Input Gate Current................................... 5-12
Horizontal Page
1. Adjust Horizontal Amplifier Gain ......................... 5-13
2. Adjust X I0 Horizontal Amplifier Gain ................. 5-14
3. Adjust Magnifier Registration ............................. 5-14
4. Check Position Range ......................................... 5-14
5. Check Variable Range ......................................... 5-14
6. Adjust Delay Dial Timing ..................................... 5-14
7. Adjust High-Speed Tim ing ................................... 5-15
8. Adjust 5-ns Timing and Linearity ......................... 5-15
9. Check Timing Accuracy and Linearity................. 5-15
10. Check Delay Time Dial Range and Accuracy . .. 5-16
11. Check Delay J itte r................................................ 5-17
12. Adjust X Gain ...................................................... 5-18
13. Check X Bandwidth ............................................. 5-18
14. Check A-Sweep Holdoff ..................................... 5-18
Trigger
1. Adjust Trigger Offset ........................................... 5-19
2. Adjust Trigger Sensitivity ..................................... 5-19
3. Adjust Slope Balance ......................................... 5-20
4. Adjust P-P Auto Trigger Centering ..................... 5-20
5. Check Internal Triggering ................................... 5-20
6. Check External Triggering ................................... 5-21
7. Check External Trigger Ranges ......................... 5-21
8. Check Single Sweep Operation ......................... 5-22
External Z-Axis and Probe Adjust
1. Check External Z-Axis Operation ....................... 5-23
2. Check Probe Adjust Operation ........................... 5-23
5-3

Tektronix 2215A Specifications

General

Brand	Tektronix
Model	2215A
Category	Test Equipment
Language	English