Tektronix 3 Series User Manual

Measurement Description
Clear Table
Deletes all mask points.
See also
Power measurement configuration menu overview (optional) on page 1
14
Global Measurement Settings panel (Measurement configuration menu) on page 112
SOA Mask definition controls and fields on page 115
Measurement configuration menu
Use this configuration menu to add statistics to a measurement badge readout and change measurement settings including source,
reference levels, high-low method, gating, and number of samples.
To open a Measurement configuration menu for a measurement, double-tap a Measurement badge in the Results bar. The configuration
menu and panels only show fields and controls relevant to the selected measurement.
The menu opens on the measurement name panel (the name of the measurement), which provides controls to display additional
statistics to the measurement badge, reference levels, gating, and so on. The content of the measurement name panel depends on the
measurement. The most common Measurement Name fields are listed in the following table.
Measurement configuration menu fields, controls, and panels
Field, control, or panel Description
Measurement Statistics
(Measurement name panel)
A list of measurement statistics related to the measurement. You can add these statistics to a
measurement badge by selecting the Show Statistics in Badge control.
Show Statistics in Badge
(Measurement name panel)
Adds the listed statistical measurement readouts to the measurement badge readout.
Source
(Measurement name panel)
Sets the source and slope for the measurement. The number of controls is specific to each
measurement type.
Info:
(Measurement name panel)
Displays measurement warnings for the measurement.
Global Measurement Settings
panel
Sets the reference levels and units used to take measurements, the gating method, the method used
to calculate the T
op and Base waveform values, and the number of samples. See Global Measurement
Settings panel (Measurement configuration menu) on page 112 for more information.
Measurement Name panel (Measurement configuration menu)
The Measurement Name panel (the name of the measurement) provides controls for adding measurement statistics to the measurement
badge and opening plots of the measurement.
T
o open the measurement name panel, double-tap a Measurement badge. This is the default panel shown when you open a Measurement
settings menu.
The content of the Measurement Name panel depends on the measurement.
Menus and dialog boxes
3 Series Mixed Domain Oscilloscope Printable Help 111

Tektronix 3 Series Specifications

General

Brand	Tektronix
Model	3 Series
Category	Test Equipment
Language	English