Field or control Description
Decode Format Sets the decode format used to display the bus information. Formats are Hex and Binary.
Other bus types
Serial bus types, such as CAN, LIN, Ethernet, and so on, are available as purchasable options. Once purchased and installed, the new bus
types are shown in the Bus T
ype menu. The serial bus options also add corresponding bus trigger capabilities to the Trigger menu.
Use the following links to access information on specific Bus configuration menus.
Parallel Bus configuration menu on page 127
I2C serial bus configuration menu on page 123
SPI serial bus configuration menu on page 131
RS-232 serial bus menu on page 129
CAN serial bus configuration menu on page 120
LIN serial bus configuration menu on page 124
FlexRay serial bus configuration menu on page 122
Audio serial bus configuration menu on page 118
USB serial bus configuration menu on page 132
MIL-STD-1553 serial bus menu on page 126
ARINC429 serial bus menu on page 117
See also
Bus Trigger configuration on page 199
Bus Search configuration menus on page 135
LIN serial bus configuration menu
Use this menu (optional) to set up and display a LIN (Local Interconnect Network) serial bus waveform.
To set up the LIN serial bus:
• To create a new LIN bus waveform, tap the Add Math Ref Bus badge on the Settings bar and select Bus. Open the bus configuration
menu by double clicking on the badge. Set the Bus Type to LIN.
• To change the settings on an existing LIN serial bus waveform, double-tap the LIN Bus waveform badge and make necessary
changes.
LIN serial bus menu fields and controls
Field or control Description
Display Turns on or off displaying the bus in the Waveform view.
Table continued…
Menus and dialog boxes
3 Series Mixed Domain Oscilloscope Printable Help 124
To Next Page
Loading...
Need help?
General
