Tektronix 3 Series User Manual

Field or control Description
Mode & Holdoff
Trigger Mode determines how the instrument behaves in the absence or presence of a trigger event.
Holdof
f sets the amount of time the oscilloscope waits after a trigger event before detecting and
triggering on the next trigger event.
For additional information on Trigger Mode, Holdoff, forcing a trigger, and the Trigger Frequency
Counter see Mode and Holdoff panel on page 226.
Act On Trigger
Set the actions the instrument takes when a trigger event occurs.
For additional information on the Act On Trigger panel see Act On Trigger configuration
menu on page 227.
FlexRay serial bus trigger settings panel
Use the Flexray bus menu (optional) to set up and display a Flexray automotive network serial bus waveform.
Note: Requires option SRAUT
O.
Field or control Description
Source Select the FlexRay bus on which to trigger
.
Trigger On Select the type of information on which to trigger: Start of Frame, Indicator Bits, Identifier, Cycle Count,
Header Fields, Data, Identifier & Data, End of Frame, or an Error.
Indicator Bits Select the indicator bits type on which to trigger: Normal (01XX), Payload (11XX), Null (00XX), Sync
(XX10), or Startup (XX11).
Available when Trigger On = Indicator Bits.
Frame Type Sets the end of frame type on which to trigger (Static, Dynamic (DTS), ALL).
Available when Trigger On = End of Frame.
Error Type Sets the error type on which to trigger: Header CRC; Trailer CRC; Null Frame, Static; Null Frame,
Dynamic; Sync Frame; or Startup Frame (No Sync).
Available when Trigger On = Error.
Trigger When Sets the trigger when condition.
When set to Inside Range or Outside Range, fields are displayed to set a high and low boundary
pattern for the specified trigger type.
Available when Trigger On = Identifier or Cycle Count.
Identifier Sets the frame identifier pattern on which to trigger.
Tap the Binary, Hex, or Dec field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Available when Trigger On = Identifier, Identifier & Data, or Header and Trigger When Data is not
set to Inside Range or Outside Range.
Table continued…
Menus and dialog boxes
3 Series Mixed Domain Oscilloscope Printable Help 204

Tektronix 3 Series Specifications

General

Brand	Tektronix
Model	3 Series
Category	Test Equipment
Language	English